You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm using the latest mission planner on windows PC , Matek F405-Wing FC with Arducopter Firmware (stable-4.4.4/MatekF405-Wing)
HGLRC M100-5883 GPS with Compass. When I tried to calibrate the compass MP does nothing. GPS is connected to Tx3 and Rx3 (Serial 3) with CL2 and DA2 connected as per the diagram on Matek website (https://www.mateksys.com/?portfolio=f405-wing#tab-id-6) .
I haven't changed any parameters from the list
I'm trying to calibrate it indoors without a GPS lock
If I flash the INAV firmware onto FC , then I can calibrate Compass without any issues.
From the screenshot below , I dont see the top compass priority table. I tried enabling all 3 compass and also with only Compass 1 enabled. When I click the start button nothing happens. I would assume Mag1 field would show some progress but it stays blank.
Version
What version was the issue encountered with
Platform
Copter
Airframe type
Quad-X
Hardware type
Matek F405-Wing
Logs
Please provide a link to any relevant logs that show the issue
The text was updated successfully, but these errors were encountered:
This is more likely to be a flight code issue or configuration issue rather than a Mission Planner issue. Could you post in the Copter-4.4 support forum (or use the latest beta and then report in the Copter-4.5 support forum) and if at all possible please include an onboard log (LOG_DISARMED may need to be set to 1 in order to produce a log while disarmed).
Issue details
I'm using the latest mission planner on windows PC , Matek F405-Wing FC with Arducopter Firmware (stable-4.4.4/MatekF405-Wing)
HGLRC M100-5883 GPS with Compass. When I tried to calibrate the compass MP does nothing. GPS is connected to Tx3 and Rx3 (Serial 3) with CL2 and DA2 connected as per the diagram on Matek website (https://www.mateksys.com/?portfolio=f405-wing#tab-id-6) .
I haven't changed any parameters from the list
I'm trying to calibrate it indoors without a GPS lock
If I flash the INAV firmware onto FC , then I can calibrate Compass without any issues.
From the screenshot below , I dont see the top compass priority table. I tried enabling all 3 compass and also with only Compass 1 enabled. When I click the start button nothing happens. I would assume Mag1 field would show some progress but it stays blank.
Version
What version was the issue encountered with
Platform
Copter
Airframe type
Quad-X
Hardware type
Matek F405-Wing
Logs
Please provide a link to any relevant logs that show the issue
The text was updated successfully, but these errors were encountered: