Issue when material diameter is set to large values

[Bikingcrazy52]

Hi,

I use Cura to print to make toolpaths for a custom printer that uses material approximately 22 mm in diameter, thus extrusion speeds are much slower than with 2.85 mm filament.

The issue is that ArcWelder kinda falls apart when the material diameter is set to these values.

For example, if i create a simple STL that is just a 10 mm diameter disk and slice it with ArcWelder enabled and a standard material diameter of 2.85 selected, it will create one nice 10 mm arc for the OD.

If all I do is change the material diameter in machine settings-->Extruder 1-->Compatible material diameter: 22 mm ( and I also made a custom material that is 22 mm in diameter) ArcWelder creates like 10 arcs and segments to make what should be one.

Any ideas?