You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Currently, the Draft workbench only allows creation of a rectangle from two points. As a feature request for usability improvement and efficiency, it would be useful to have the ability to create a rectangle from the center, analogue to the Centered rectangle command that the Sketcher workbench introduced in FreeCAD 0.20.
Is there an existing issue for this?
Problem description
Currently, the Draft workbench only allows creation of a rectangle from two points. As a feature request for usability improvement and efficiency, it would be useful to have the ability to create a rectangle from the center, analogue to the Centered rectangle command that the Sketcher workbench introduced in FreeCAD 0.20.
Full version info
Subproject(s) affected?
Draft
Anything else?
No response
Code of Conduct
The text was updated successfully, but these errors were encountered: