Troubleshooting and help and assistance for fresh install #1191
Replies: 4 comments
-
If the sampling rate missing errors are increasing, you need to set a default sampling rate. As for the decoding errors, if they are increasing, you can also get the precise cause in the logs. |
Beta Was this translation helpful? Give feedback.
-
Hello, Thank you for answering, @vincentbernat Also, i suppose because of these sampling rate errors, i'm not getting any flows ? It seems no flows are being forwarded. What is the best way to obtain precise logs with cause ? Thank you. |
Beta Was this translation helpful? Give feedback.
-
Strangely, without any additional changes, i'm getting the information now displayed. The only actions taken were as below, but this was already performed previously :
|
Beta Was this translation helpful? Give feedback.
-
Hello @vincentbernat, To give you a status update and for the rest of the community, i'm still trying to have information from my Cisco WLC 5508 : 3 questions :
In the Visualization, i now see an "Other" exporter appear but i don't have information... Could it be the WLC ? How can i have more information about this ? Thank you ! |
Beta Was this translation helpful? Give feedback.
-
Hello all,
I set up a docker instance of akvorado and managed to get somewhere as i had some flows working correctly. Then out of nowhere, i broke something but cannot say where it went wrong as the web page showed "404 not found". Since i did not do much and it was a fresh instance, i decided I would start fresh again following the quick start guide. However, it seems i'm now stuck with sampling rate missing errors and i cannot get further.
I'm configuring 4 exporters :
2 PaloAlto FWs (which where the only ones working previously).
2 Cisco WLCs (never worked -> missing template, no input or output interface, etc...)
But still, it should display what was working before regarding the PA FWs.
I already enabled (and removed) the default sampling rate option (which was set to 100).
Is this the right place to ask for help ? The frustrating bit is that it worked in the previously. :)
I know there are several topics mentioning this and even the Troubleshooting section of Vincent, but i'm still stuck.
Thank you !
Beta Was this translation helpful? Give feedback.
All reactions