You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a Garo wallbox connected to my homeassistant via wifi.
The garo_wallbox addon is running on the homeassistant and also displays all values.
I can also access the wallbox's web interface via the local IP.
Unfortunately, I always get the following error message in the log with the evcc addon:
"[lp-1 ] ERROR charge timer: modbus: length in response header '12081' must not be zero or greater than '254'"
Current configuration:
HA-Core
2024.3.3
HA-Supervisor
2024.03.1
HA operating system
12.1
HA frontend
20240307.0
Garo Wallbox: GLBDCMW-T211FC connected via wifi
No wallbox is displayed under the device settings - only the Volvo.
On the overview page, however, the Volvo is always shown as "not connected" even if the charging cable is connected and I start the wallbox via Home Assistant or web interface
The text was updated successfully, but these errors were encountered:
Hello everyone,
I have a Garo wallbox connected to my homeassistant via wifi.
The garo_wallbox addon is running on the homeassistant and also displays all values.
I can also access the wallbox's web interface via the local IP.
Unfortunately, I always get the following error message in the log with the evcc addon:
"[lp-1 ] ERROR charge timer: modbus: length in response header '12081' must not be zero or greater than '254'"
Current configuration:
HA-Core
2024.3.3
HA-Supervisor
2024.03.1
HA operating system
12.1
HA frontend
20240307.0
Garo Wallbox: GLBDCMW-T211FC connected via wifi
No wallbox is displayed under the device settings - only the Volvo.
On the overview page, however, the Volvo is always shown as "not connected" even if the charging cable is connected and I start the wallbox via Home Assistant or web interface
The text was updated successfully, but these errors were encountered: