You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I just went through and built a blot from one of the demo kits in the office.
There's an instruction to add a nut to a nut trap in the Printed Rail component:
The nut isn't referenced again until Final Assembly, 2 chapters later:
In between the steps, the nut fell out of the trap multiple times:
I'd suggest adding the nut trap, and adding the belt bearing assembly in the Printed Rail component chapter, then only needing to add the belt during final assembly.
The text was updated successfully, but these errors were encountered:
I just went through and built a blot from one of the demo kits in the office.
There's an instruction to add a nut to a nut trap in the Printed Rail component:
The nut isn't referenced again until Final Assembly, 2 chapters later:
In between the steps, the nut fell out of the trap multiple times:
I'd suggest adding the nut trap, and adding the belt bearing assembly in the Printed Rail component chapter, then only needing to add the belt during final assembly.
The text was updated successfully, but these errors were encountered: