You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I got everything running, initailizing the radio is done. But i cant find any signals at all. tried 4 different remotes, but the radio does not pcik up anything. not in logfilæes, not upon scan frequencies.
Wiring is:
Radio Module - color - ESP32 board
1/GND - Grey - GND
2/VCC - Purple - 3,3
3/GDO0TX - Blue - 13
4/CSN - Green - 05
5/SCLK - Yellow - 18
6/MOSI - Orange - 23
7/MISO - Red - 19
8/GDO2RX - Brown - 12
How to reproduce it (step by step)
1. Go to...
2. Click on...
...
Logs
No response
The text was updated successfully, but these errors were encountered:
Ok I have determined that your wiring is correct if your radio pin settings look like this.
Just to be sure your remotes do not say IO on them anywhere when your read the back of it. The led on RTS remotes will most often be red in color when you press a button on the remote. The radio for IO HomeControl is fundamentally different and will not work with this solution. This only works with RTS.
If that is the case verify that you also have 433.42mhz selected.
Hardware
ESP32
Firmware version
v2.4.1
Application version
v2.4.1
What happened? What did you expect to happen?
I got everything running, initailizing the radio is done. But i cant find any signals at all. tried 4 different remotes, but the radio does not pcik up anything. not in logfilæes, not upon scan frequencies.
Wiring is:
Radio Module - color - ESP32 board
1/GND - Grey - GND
2/VCC - Purple - 3,3
3/GDO0TX - Blue - 13
4/CSN - Green - 05
5/SCLK - Yellow - 18
6/MOSI - Orange - 23
7/MISO - Red - 19
8/GDO2RX - Brown - 12
How to reproduce it (step by step)
Logs
No response
The text was updated successfully, but these errors were encountered: