Skip to content

Burn HM-10 (CC2541) and Zigbee (CC2530 CC2531) firmware using NodeMCU board.

Notifications You must be signed in to change notification settings

Jason2866/CCLoader

 
 

Repository files navigation

CCLoader

Burn CC25xx/HM10 firmware using a NodeMCU or Wemos D1 mini.

Flashing CC2530 or CC2531

Use the files provided in folder Bin. The BIN files are already converted and ready to flash with CCLoader
Detailed Zigbee flashing information. Thx @blakadder

Flashing HM10 (CC2541) or CC2540

  1. Wire the pins:
Pin Name Pin# NodeMCU/Wemos Pin GPIO#
P2_1 (DEBUG_DATA) Pin #8 D5 GPIO14
P2_2 (DEBUG_CLOCK) Pin #7 D2 GPIO4
RSTB (RESET_N) Pin #11 D1 GPIO5
3.3V Pin #12 3.3V
GND Pin #13 GND

imageimage

image

  1. Use CCLoader.exe to load the CC2541hm10v707.bin firmware via the NodeMCU to the HM-10 with command:
    CCLoader_x86_64.exe [Number of the COM port] CC2541hm10v707.bin 0
    image

  2. You should see a result similar to

image

Troubleshooting

If you're not sure the flash succeeded connect to HM-10 module over serial and issue AT+VERR commands which should show v707.

If you cannot communicate with the HM-10 module even after a successful firmware flash change you serial terminal baudrate to 9600, then issue AT+RENEW command which should reset the module to firmware factory settings and the proper 115200 baudrate.

Help Video

You can Up- and Downgrade to other firmwares using the Manufacturer upgrade tool.

More Information

Releases

No releases published

Packages

No packages published

Languages

  • C 60.7%
  • C++ 39.3%