ista EcoTrend Version 3

---

Installation

MANUAL INSTALLATION

Copy the ecotrend_ista last Release folder and all of its contents into your Home Assistant's custom_components folder. This folder is usually inside your /config folder. If you are running Hass.io, use SAMBA to copy the folder over. If you are running Home Assistant Supervised, the custom_components folder might be located at /usr/share/hassio/homeassistant. You may need to create the custom_components folder and then copy the localtuya folder and all of its contents into it Alternatively, you can install localtuya through HACS by adding this repository.

INSTALLATION mit HACS

1. Ensure that HACS is installed.
2. Search for and install the "ecotrend ista Integration" integration.
3. Configuration for the ista EcoTrend integration is now performed via a config flow as opposed to yaml configuration file.
4. Restart Home Assistant.

---

Basis Configuration

1. Go to HACS -> Integrations -> Click "+"
2. Search for "ista EcoTrend" repository and add to HACS
3. Restart Home Assistant when it says to.
4. In Home Assistant, go to Configuration -> Integrations -> Click "+ Add Integration"
5. Search for "ista EcoTrend" and follow the instructions to setup.

ista EcoTrend should now appear as a card under the HA Integrations page with "Configure" selection available at the bottom of the card.

---

Two-factor authentication (experimental)

• Two-factor authentication deutsch
• Two-factor authentication english

---

Debug

logger:
  logs:
    custom_components.ecotrend_ista: debug