(c) Jan Kåre Vatne (jkvatne@online.no) 2022 The program is released under a MIT license, and you are free to use/copy/modify the program as you like.
This is a Altium Script project that contains a Delphi Script for importing testjig data. It takes a gerber file generated by Macaos, and generates a PcbDoc file with pads for test pins, and a connector for measurements. Net names are imported, and a board outline is defined according to gerber data.
Open the TestPinBoardgenerator project in Altiuim Designer Open the CreateTestjig.pas script
Create a new PCB with your prefered settings and rules. While this pcb is in focus, go to the menu File | Run Script.. Click on TestPinBoardGenerator -> CreateTestjig -> Run You will then be queried for the Maccaos mtt file. Select it and click ok.
It will generate a new PcbDoc board. Save itto your project directory.
If a schematic is required, make sure the TestPins.SchLib is open and available.
The select File | Run Script... and select CreateTestjigSchema->Run
There are a few constants at the top of the file that can fine tue hole diameters etc. There is also a default file name. Setting it to a file path will skip the file-open dialog.
The pin sizes are set to allow 2mm test pin minimum distance with 0.2mm clearance and 0.3mm anualar ring.