Temporarily Replace Player or Enemy Party Pokemon

Introduction

This branch allows you to temporarily replace player/enemy party Pokemon with a "createpartymon" scripting command. For the player, all you have to do is save your party with special SavePlayerParty, use the command, then do special LoadPlayerParty after a trainer battle. For the enemy, you need to set FLAG_ENEMY_PARTY, which replaces the enemy's usual party with the party you specify, and then run the command before a trainer battle. Make sure to clear the flag afterward, if you want to go back to normal trainers.

Installation

Just do git remote add petuh https://github.com/Petuuuhhh/pokeemerald followed by git pull petuh createpartymon.

Warnings and Possible Issues

Be aware that ZeroEnemyPartyMons() does not get run if you set the flag and then start a trainer battle, so if you load in a party with 6 Pokemon, and then next, load in a party with 5, there might be a leftover sixth Pokemon from before (haven't tested, yet). It might even carry over a previous normal trainer's Pokemon if you load in a number that's lower than the party amount a trainer used before.

Examples

I use this scripting command to implement Smogon [Gen 3] OU team replacement in this YouTube video. It was made possible through SBird's Dynamic Multichoice.

Contributors

ghoulslash

• Created Give Custom Mon, which I largely based the code around.