Groove Coaster Controller

GrooveCoaster Controller replica with dimensions from real cabinet
Box is 20 x 10 x 56.5 cm

(part linking the ls32 and joy_stick is missing in this picture: you can look at it here)

needed

• a teensy 3.2 or 3.1
• a 3D printer
• a laser cutting machine
• 5mm plywood
• 2 x seimitsu LS32-SE joysticks
• 2 x 60mm buttons
• 2 screws for locking the top of the sticks
• 2 x large 6mm washers
• 2 x anti vibration 6mm nuts
• 8 x computer fan screws
• wood glue

things to 3d print

• 2 x joy_stick.stl
• 2 x joy_base.stl
• 2 x joy_tube.stl

things to laser cut

• 2 x box_side.dxf
• 2 x box_insert.dxf (goes on box_middle, helps for rigidity)
• 1 x box_front.dxf
• 1 x box_front.dxf (with a cut for your usb panel mount adapter)
• 1 x box_top.dxf
• 1 x box_middle.dxf
• 1 x box_bottom.dxf

assembly

warning: look at the picture ! be careful on which way goes up during the box assembly ! box_middle should be closer to top, not to bottom

• assemble the printed joy_tube on the ls32 sticks using the washer and the nut
• screw the ls32s to the box_middle (joysticks under the board) using the fan screws
• glue the joy_bases to the box_top (wood glue should do it)
• assemble the sides, front and top panel using the glue
• assemble the 60mm buttons on the joy_sticks, and solder the wires to them
• assemble the joy_sticks on the joy_tube
• solder wires to the ls32s
• solder everything to the teensy
• assemble bottom panel and then rear panel when you confirmed everything works

soldering

• Solder a GND wire to all leds and buttons
• Solder pins A5, A6, A7, A8 and 3, 4, 5, 6 to left and right joysticks
• Solder pins A4 and 7 to left and right buttons
• Solder pins A3 and 8 to left and right leds